Vehicle & Technical > Discovery
Side exit exhaust
landroverkeith:
--- Quote from: Disco_Stu on June 24, 2008, 10:08:24 ---Good question. I'll get the mic out on wednesday evening, I'm at work until then I'm afraid. Will post then.
--- End quote ---
ta much cant wait :dance:
Disco_Stu:
Kieth, measured the pipe tonight, its 57mm outside diameter. I had to cut the flexi and cut my exhaust (2 slots either side with the cutting disc) to make them compress/expand and fit. I reckon a slightly bigger flexi, maybe 60/62mm ish would slide over the exhaust nicely.
Good luck mate and put some pics up when you're done.
Stu.
auf_wiedersehen_pet:
Disco Stu....
You've had this mod for a while now, how has it been?
Do you get any vibration at all?
I've done lots of research and have sourced the same bits as you - so I'm looking to go ahead soon.
Ja1983:
how did you go on with the hanger? i suspect the cable (?) may not survive too long??
Disco_Stu:
It's lasted really well, no issues whatsoever with the flexi, joint etc. The chrome tailpipe has started to get a little pitted on the underside but what do you want for £6.99?
The cable was on for about a month, surprisingly it showed no signs of wear or heat damage at all. I happened to come across a big jubilee clip when I was sorting some tubs in my garage so I stuck that on instead.
I'd say go ahead Pet, its a cool mod :)
Stu.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version