Chat & Social > The Bar - General Chat
Workshop Section of Mud-Club
Disco Matt:
With any luck I should be replacing the idler bearing in my air conditioning compressor soon (the old one whines after a deep ford!). I'll take photos for use if this idea works. I have seen an Aussie site talking about doing this (where I learned that it was possible) but the more places that have the information the better. Looks like a new bearing will cost me £16 or so compared to the £140 a main dealer wanted to replace the pulley!
andrew2986:
Next time I do any work on the disco will take some pics, if workshop section comes back on line would be happy to post them.
It doesnt have to be just drawings for fabrication? does it?
photo how to's on wheel bearings, brake pads, lines, lift kits etc might be a great help.
Rasbo:
i think anything that would help fellow owners would be a great help, so no, not just drawings. step-by-step guides with pics would especialy be helpful etc.
spud the king:
think the hole idear is spot on as i did a lift on my disco and had no idear off how to go about it , i did it though but the hard way and have looked at making my bits [ sump gard and tank gard] but then you need one to make one if you know what i meen cos photos in mags and that dont have much info or photos from all angals
BeJay:
This, http://forums.lr4x4.com/index.php?showtopic=14285 with acknoledgement (and all credit to) Les Henson is the perfect example of how helpful this type of section can be, I think it would be very hard to find an easier to follow and clearer step by step explanation with pictures of this particular job anywhere on the net, well done Les :clap: :clap: :clap: a brilliant and extremely helpful post.
...........cheers, Jack.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version