Vehicle & Technical > Discovery

Fuel stop solenoid switch

<< < (2/2)

Range Rover Blues:

--- Quote from: Disco Matt on April 15, 2008, 16:07:54 --- knowing my luck I'd forget to unlock it myself one day  :lol:

--- End quote ---

I've driven into my yellow security posts.  Not once but twice :roll:

David Gray:
Use a 6 inch square piece of ply-wood draw a line from corner to corner where the lines cross drill a hole, knock a six inch nail with sharpened point through the hole, place the whole thing inside a cushion cover and leave on drivers seat when un attended better than any imobiliser.

90Mike:

--- Quote ---Use a 6 inch square piece of ply-wood draw a line from corner to corner where the lines cross drill a hole, knock a six inch nail with sharpened point through the hole, place the whole thing inside a cushion cover and leave on drivers seat when un attended better than any imobiliser.
--- End quote ---
:clap: :clap: :clap: :lol:

treeman:
what iv done to mine is extend the wire from the back of the fuel pump thrugh to underneath the dash and put a switch on it,cant even start it with the keys either... no fuel no go  =;, immobile all for the price of a switch an a bit of wire  :lol: :lol: :lol:

lee celtic:
I have a presure pad out of an old car (jensen healy) used to stop the engine running if the seat belt is not used, it goes inside the drivers seat and there is a hidden switch to disable it and a little creative wiring in the engine bay so if your sat in the seat it won't run ;)

This is in adition to the six wire imobiliser I got of ebay  :lol:

Navigation

[0] Message Index

[*] Previous page