Pages: [1]   Go Down

AuthorTopic: 4WD light  (Read 907 times)

0 Members and 1 Guest are viewing this topic.

Offline Lincs niva

  • Posts: 1031
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
4WD light
« on: April 14, 2008, 07:18:13 »
On my 97 vit the 4wd light is staying on although it's not in 4wd..Whats the cause of this anybody no.I did have the rear part of the centre console out yesterday..

Cheers Gav
Logged
Yorkshire and Lincolnshire 4x4 Response
www.yorks-lincs4x4response.org

Offline generation-x

  • Moderator
  • ***
  • Posts: 2057
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • Mega-Fronty
    • church stretton
  • Referrals: 0
Re: 4WD light
« Reply #1 on: April 14, 2008, 21:49:19 »
Gav
if you remove the cover from over your handbrake and t-casr lever and take the t-case lever rubber seal thingy you will see jsut infront of the t-case lever and couple of wires conected to a plunger switch pull the 2 pin plug apart and undo the switch and give it a clean and grease and re insert this shud do the job

simon :angel:
Logged

Offline Lincs niva

  • Posts: 1031
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: 4WD light
« Reply #2 on: April 15, 2008, 06:12:02 »
Cheers Simon i shall have a look :D

Cheers Gav
Logged
Yorkshire and Lincolnshire 4x4 Response
www.yorks-lincs4x4response.org
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal