Vehicle & Technical > Series Land Rovers
200TDi in me lightweight, update on build! :)
baron von ledwidge:
Just out of interest what did you do about running wires to the starter solenioid
Its just im thining of putting a tdi in my landy and trying ot get my head around it
aaron
lightweight-love:
disco starter motor has solenoid on it so im gonna use that one, u could by-pass it and use the existing series 1 if u wanted. yeh lots of bits to get your head around but wiring isnt one of them! just fuel cut off and starter motor! love it!
Devon-Rover:
most use the disco solenoid on the starter, just extend the red and white trigger wire down to it.
The stop solenoid just use the white feed that used to go to the Coil.
lightweight-love:
everything is now finished wid engine change! drives well and will plod along happily being as economic as possible, but then u can give it some gas and it can shift! is a great feeling accelerating like that in a series!
gearbox-wise it feels fine and i think driven respectably will be ok! 'but' if it does go and i decide to go for a different box whats the best alternative then? an R380?
couple pics showing the lowest point of exhaust(all made from disco bits!) is higher than x-member and behind shackles so is fine like that,
and iv used a 300tdi airbox and fitted the rocker breather into it!
lightweight-love:
pic 2
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version