Vehicle & Technical > Discovery

Sills?

<< < (2/3) > >>

Cheggs:
On my disco the sills had rotted but the floor was ok so got some new sills for aRRC and trimed them and had them welded over the old sills then fitted some rock sliders with tree guards from Guardian. RRc part was half the price of the Disco part, but doesnt have the holes for the plastic rivets that hold the plastic over sill on. But you coulds always mark and drill.

stuntman:
60*120*1400 is the exact length to go in place of the sills

Disco-Ron:

--- Quote from: stuntman on April 01, 2008, 11:37:48 ---STOP!!!!!

This is the best time to stick some box section steel in, 60*120*1400 at 4-5mm thick, cut a slant at each end then plate over, these are great rock sliders, I did both of mine in under  5 hours, and they have been severly abused without fear of damaging the sills.

Total cost from local metal merchant was around £35 ish

Andi

--- End quote ---

Any pictures, cos my disco is heading this way.....!!

stuntman:
No worries, I'll try to get a couple up in the next few days, although I'm sure someone posted a link when i first started asking about rock sliders.

Andi

python:
im going the slider route also. stuntman how did you get around the bit at the bottom of the b'' pillar. between the doors.?

Navigation

[0] Message Index

[#] Next page

[*] Previous page