Vehicle & Technical > Discovery

extending the hi low gear stick.

(1/2) > >>

clover:
Right I've finally had enough.

Got to do something about the hi low diff lock gear stick on Pinky.

I need to extend it in length by 2".

Basically since I did the body lift you can only get it in Hi diff lock if you take the gaiter off it. I have noticed that on a motorway journey you get all kind of unpleasant fumes into the cabin as a result.

If I had access to a lather I could turn something up in no time at all. Get a piece of bar drill and tap a hole in the end. Turn it round the other way and cut down to the required diameter and run a die down it to cut the required thread...

Trouble is I've not got access to a lathe.

Anybody got any suggestions? I don't know any local engineering firms that would do a small on off job like this.

Cheers

John

Dr.Ed:
think you want an extension nut:

http://www.wixroyd.com/products/pdf/w__207-collar-nuts.pdf

that and a short length of threaded bar should do you!

wizard:
I think i might have a few gearlever extentions knocking about.
PM me your address and i will post you one.
Regards
wizard

Bobtail:

--- Quote from: wizard on March 31, 2008, 15:53:59 ---I think i might have a few gearlever extentions knocking about.
PM me your address and i will post you one.
Regards
wizard

--- End quote ---

Could i have one too please

I am willing to reimburse you

thanks

Jim

wizard:
Pm me your address and i will see what i have available.

regards
wizard :twisted:

Navigation

[0] Message Index

[#] Next page