Vehicle & Technical > Discovery

7.50 Trac Edges will they fit

(1/2) > >>

craigiow:
picked up some BFG at tyres, 7.50/16s trac edge.

the tyre fitting guide says bit of trimming and maybe steering and bump stop

does this mean I can get them on before I Lift it or will it be a tight fit ?

Range Rover Blues:
I wouldn't like to say yes without a lift, you'll hit the bodywork and front bumper.

mentalmoshio sophs V8i:
if u trim the archs abit front and back and front bumper and fit extended bump stops shouldnt be to bad. gav t runs that set up

Jake:
You can fit them without any modifications, just dont go over anything bigger than a small kerb or turn full lock  ;)
You can run that size with a 1" lift and the Camel Cut but they might snag the front bumper (Gords disco was 1" with the same size (235/85R16))
What wheels are you fitting them too? Steels or alloys?
If their steel, are they mods/8 spokes or standard lr rims?
The reason for these questions is with wheels like mods or 8 spokes the tyres will be more off set than standard and will cause you more problems without lifting due to fouling the bodywork.
 :D

Gav_T:
I ran 235/85/16's on land rover alloys without a lift so in theory 7.50's should fit because they are narrower. I just put longer bolts in the steering stops and did a camel cut.

BTW im running 265/75/16's on mods without a lift but i have arches now  :twisted:

Gavin

Navigation

[0] Message Index

[#] Next page