Vehicle & Technical > Discovery
My Disco progress so far
mikiep1986:
i must say i do like that bumper looks very nice a tidy :clap:. might give it a go making one for my disco :lol:
Chris Putt:
That Bumper is spot on! you dont fancy knocking up another one for some beer tokens do ya!!! :lol: Keep bending my current one :(.
Steven:
I do like the lights in the bumper mate, well done very nice.
Theres only one other person, well a company which have done that.
meader:
very nice job and i do like the lights as we no with landy lights there not the best but im sure they will light up the road a bit better
TDi.Si:
I haven't seen any with lights in before, apart from my mates on his SJ :D
I found I have wet carpets after a trip to Marlborough so thourght i'd get on with welding up the sides of the floor and front inner wings.
Out came the grinder
Seat belt mount was shot
2 small holes by the rear door
Welded new sides of the floor in
Sills only had one small hole!
Both inner arches had holes where the mud flap brackets were
Drivers side inner wing was shot all the way around, even under the headlight
Passenger side wasn't as bad
Took me 2days of welding, although my welder has gone wrong :angry: The new floor pannel I used was a RR clasic one which I had in the garden. Had to cut it down about 3 inches, then rivited in. I did disturb the fuel return pipe though so I had to change the sender unit, luckily I had another tank though.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version