Vehicle & Technical > Defender

Parts to fit a roll cage

<< < (2/3) > >>

Guardian.:
itl be my screen then. good, cuz it looks a good bit of kit.

extreme90:
looking at the picture id say its very similar to a whitbread cage, if not a whitbread cage

electricbluebadger:
Had to do a double take for a moment then, its almost identical to the cage I fitted to my lightweight and you house must've been buily by the same builder :) ... its not an MQ is it??



Cheers Steve

electricbluebadger:
Forgot to add, i cut round holes in the floor plates and welded the front direct to the outriggers on top of a reinfirced plate, behind the bulkhead I welded square plates to the top of the chassis and bolted to the flat plates on the cage after drilling em. I cut off the rear stays and welded them back on angled to the seat box tops so I could fit forward facing buckets in the rear for the kids.

Cheers Steve

zulublue:

--- Quote from: extreme90 on February 24, 2008, 21:29:06 ---try devon 4x4 they sell there cage fitting kits seperate..
or
north offroad
whitbread
P+P
do you know who made the cage

if all else fails
speak nicely
ill fit it for you * sighs as he loves to fit rollcages
dan

--- End quote ---

Cheers Dan, is it worth me getting a brace that goes across the front windscreen?

I have been told it is CDS tube and made by Betterweld

Navigation

[0] Message Index

[#] Next page

[*] Previous page