Vehicle & Technical > Discovery

best way to cut arches jigsaw or nibbler??

<< < (2/2)

Guardian.:
not al repblagh saws are destructive, my mate has a hand held snap on one its well tidy for doing that sort of thing, i used it.

MudRat:
Nibbler on wings, jigsaw (with masking tape on the bed AND the wing for the back, and any tuff bit Stainless cutting disk on an angle grinder,

windowlicker:
thanks for your comments it seems it down to personal preference  as when it comes down to it i guess all the different methods eqate to the same thing and do the same job.

i think i will just take a little bit off at a time and try all the above before i make the final cut just to get the feel of it although im a bit concerned about using a grinder incase it melts instead of cuts!!!

Range Rover Blues:
What you want is called a cut-off tool, does what it says on the tin ;)  It's a non-angled grinder with a narrow high speed blade.  Most are air powered but I've seen electric.

mobi:
i used a jigsaw just masking tape over the panel do your line then start cutting, don't forget to put oil on the blade.
i did the back doors this way too, just take your time on the double skin on the doors.

Navigation

[0] Message Index

[*] Previous page