Vehicle & Technical > Discovery

Fuel tank guard... work in progress

<< < (7/10) > >>

Range Rover Blues:
Looking good mate.

Did you say 6 bolts through the chassis?

and what's the pressure guage for then :-.

wizard:
I used the four original tow bar bolt holes and another two holes further back where i have a set of twin rear shocks mounted.

The pressure guage is for the on board air system. There is a pnumatic stab-in just to the right of the guage.

I mounted the guage into the rear bumper today and put on two new towing sockets.
Hopefully i can remount the bumper tomorrow after i finish work and before the rugby starts.

regards
wizard :twisted:

PITBULL:
that looks wicked mate been thinkin bout changing my scorpion racing detachable tow bar and tank guard for the southdown version/type :wink:

p.s. we have met b4 set your sight back a couple of months (well quite a few actually) you went off roadin with a guy who works with Mrs wizard in a red disco i am his son that was with him also heard you no a couple of the guys from BONKAS small world eh

Range-Stormer:
Wizard it looks great...

I am looking at these from Southdown or Guardian but they are very expensive or getting a replica Scorpion detachable tow bar and a standard tank guard.

If this goes into production put me on the waiting list...

Cheers

Julian

wizard:
Just about finished.







wizard :twisted:

Navigation

[0] Message Index

[#] Next page

[*] Previous page