Vehicle & Technical > Defender

Water Proofing

<< < (2/3) > >>

Paul:

--- Quote from: "ooheck" ---Motorbike chain lube works for me.
--- End quote ---


Same here, It's good stuff.

dazzawhipple:

--- Quote from: "ooheck" ---Motorbike chain lube works for me.
Easy to spray all those hard to reach areas, and sets like treacle!
--- End quote ---



I was thinking about thick grease this may be the stuff i need

iianorthants:
the 2.25, don't normally suffer like the V8's. I've tried grease and silicon and such, but just attracts the dirt and when you need to check dizzy or coil, you have twice the job of cleaning and watching out for contaminates, the coil should be mounted out of the way (i use something similer to KY as don't eat rubber just to protect incase of any splashing)
 Marigolds own for the four cyl car's as you just cut the fings off and feed leads through (i tie-wrapped fingers to leads with a bit of silicon sealant inside) then just cover dizzy useing an elastic band to seal while off-roading then just fold up for day-2-day use.

unknownmanxman:
I coat all the ignition bits in duck oil... ive made a cover for the dizzy out of an old plastic 5 litre drum to stop water from the fan firing straight into the dizzy, and i put the coil in an ice cream tub.... i just put the lid on when i go offroad... its worked fine..


Jon

dazzawhipple:
Many Thanks for all the replies ..................... I used a rubber glove and It worked a treat , didn't fail me once

Navigation

[0] Message Index

[#] Next page

[*] Previous page