Vehicle & Technical > Discovery
A Frame problem
Range Rover Blues:
If you have a decnt tool shed around DREMEL sell a hard cutting disk like a cut-off disk that will last a lot longer, or if you have access then a cut-off tool (air tool) might be easier to get in than LR special tool No.2, (the angry grinder).
Worst comes to worst, trash the arm and cut through it, you'll feel better you know you will, and put a S/H arm on.
JDB:
When I had a similar problem doing all my suspension bushes I found (on EvilBay) 1mm cutting discs for an angle grinder, they are quite fragile sideways (!!) but are effectively as "narrow" as a hacksaw blade and make light work of cutting bushes out, but do buy a couple extra.....
Hope this helps.
Henry Webster:
Yup cutting disk on the grinder, oxy acetelene cutter and alot of a nightmare.
I am feeling your pain.
We had to do it the day before the Baja GB when we found some play. Managed to trash two bolts and the front to back brake pipe. That was quite alot to do in one evening. Why is it you always find these things at the last minute. I'd been working on the car for weeks!
H
Ja1983:
a common disco problem.....
my advice - pay someone else to do it! :lol:
Big Rich:
Thanks to wd 40 and my trree wedges the little [-X bolt is off. All sortred now. Well one of my fleet is. Now the next one :roll:
Many thanks
Rich
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version