Vehicle & Technical > Discovery

52mm hub nut tool

<< < (6/6)

daveyravey:

--- Quote from: Skibum346 on February 02, 2008, 22:41:37 ---
--- Quote from: martinwf5 on February 02, 2008, 18:47:56 ---I was looking on previous posts about the hub tool , and the link on paddocks and difflock tool shop comes up an error, is there any where else i can purchase one?

i dont want one with the bar, i require the 3/4 or 1/2 drive just in case i have to replace the bearings when i change the discs and pads this week,

thanks

Martin


--- End quote ---

Not all socket sets come with them these days, but I remember looking at one piece in my old man's set as a kid trying to figure out what on earth it was used for... it was a square drive on a bar that could slide up and down. I discovered it's to fit things like hub nut spanners... slide one end into the two holes at the end, then fit a small/bigg/kinooge ratchet handle as required!

In the pic below it's immediatly above the ratchet handle.



Skibum

--- End quote ---


It's called a "tommy bar" Frank   ;)

BK:
ive never bothered with a torque wrench and i never have a problem,i just use the hub spanner with a long screwdriver stuck through it and just tighten it up

Navigation

[0] Message Index

[*] Previous page