Vehicle & Technical > Discovery

door seals

<< < (3/4) > >>

treeman:
PERFECT !!!! well done that man  :clap: u read my mind :lol: an that looks really neat, i took the carpets out then lifted the soundproofing an then saw the reason why its been letting in so much water so quick, rustmite :evil: so its out with the soundproofing an in with the welder(again) cheers for the link mate il give them a bell  :D

ChrisW:
They're just off the inner ring road on the A435 by the mosque  ;)
If you haven't binned it already, keep the carpet to use as a template for cutting the rubber.

NeilWilson:
Does the rubber fold around the contours of the floor & transmission tunnel easily ?, ie. is it a straight swap between the carpet and the sheeting ?
Thanks.

Neil

ChrisW:
Wasn't too difficult to fit. I had already binned the carpets and sound proofing at the beginning of the rebuild but used masking paper to make templates.
It's much easier to fit with the seats out which isn't too difficult a job - 4x10mm bolts on each seat base.
The mats are in four sections -
Load space floor up to edge of rear seat box, floor space between rear and front seats and one each for the driver and passenger footwell.
The rubber folds quite nicely to give a continuous finish against the transmission tunnel.
If I were to do it again I think I would probably add a few extra cuts to make the mats a little bit easier to remove.
Use generous cuts as it's a lot easier to trim small bits so they fit rather than add bits to take up gaps!

crazymac:
Thats great looking stuff, did you say that you bought 3 of them? seems an awful lot of mat?

Let me know, cos I'm about to take my carpets out!

Navigation

[0] Message Index

[#] Next page

[*] Previous page