Vehicle & Technical > Discovery

SILLS

(1/2) > >>

muzzer:
I need to do my sills do I just grind the rot out and replace the bad bits, or replace the complete thing,if its the complete thing can you get replacement's to weld on.or am I best getting someone to do it for me,

stuntman:
Muzzer, the best thing to do as 'upgrade' is to buy some 60x120x1400 box section steel and follow the info on the link below:

http://forums.lr4x4.com/index.php?showtopic=19704&hl=rock+sliders

Best of luck, it took me around 4hrs to do each side, also leave some time to repair the floors as they will inevitably have rot in them

Pete:
http://www.paddockspares.com/sp/category/DISCOVERY_1/subcategory/Body_and_Panels/searchbox2/3__Rear_Body_Parts.html

 Give Paddocks site a look.
 Pete.

J B:
it depends how big the holes are in the sills, and what the rest of sill is like

i patched the hole about 8" long as the rest of the sill was good, just a few small holes here and there

much easier than cutting the lot out and replacing the whole thing

mentalmoshio sophs V8i:
id go for the whole new sill, or rock sliders . as they get older new sill aint gonna want doing again and again in different places if u patch them first time around

Navigation

[0] Message Index

[#] Next page