Vehicle & Technical > Discovery

Winding up the turbo on a 300 tdi

<< < (2/2)

chris.hunt22:
I tapped a hole on the front of the plenum (inlet manifold - call it what you will) and fitted a brass fitting, it is sited on the right hand side of the plenum looking from the front and is about an inch back from the front edge, I have piped this straight into a TIM Turbo gauge that i had knocking around from my old Disco.  I am baffled by some of the other suggestions, I was advised in an earlier post I put on to go from the manifold (plenum) as this will give the most accurate reading of the actual pressure.  All advice in improving performance is greatly accepted (I have already tweaked the pump and am shortly going to flush the intercooler and pipework), I still need to know where to find the actuator rod as I cannot find it (makes it hard work with the lift and tyres on!!!)

Navigation

[0] Message Index

[*] Previous page