Vehicle & Technical > Discovery

Coil problems

<< < (2/2)

jjsaul:
NGK are usually a pretty good bet on rover v8's....dont fit the 4 pronged ones though, just stick to standard decent quality ones.
As suggested earlier in the thread, lucas stuff is about as good as it gets for leads / caps / rotor arm etc without spending a fortune.
If you're going to replace the coil, try the Lucas DLB105 Gold coil, they give a higher voltage output on the HT side, they do work, especially if running LPG.
The only improvement with leads is ones such as the Magnecor ones, but at £80-90 a set they're a bit pricey  :shock:

stageonesimmo:
I know its boring, but, you need to keep on top of the gaps as well - makes a hell of a difference especially at start-up when cold.  I used to keep a spare set of plugs, I'd pull the 'old' ones out, pop in the fresh set then re-gap the 'old ones which then became the new ones and so on... every couple of months

Navigation

[0] Message Index

[*] Previous page