Vehicle & Technical > Discovery
MOT question - Do I need a catalytic converter in my 95 300TDi for the MOT??
mud-club-matty:
even if he wire mesh is riped it wil lstill pass ours did :D or just take it of an put a non cat down pipe on it and middle box replacement pipe and keep back box.
davidlandy:
the simple answer is no
rip it off , loose the EGR , and appreciate the more low down pull it will give you.
auf_wiedersehen_pet:
--- Quote from: davidlandy on January 03, 2008, 17:58:20 ---the simple answer is no
rip it off , loose the EGR , and appreciate the more low down pull it will give you.
--- End quote ---
EGR gone already. Did not notice any difference though. Used a good kit from Cheviot4x4.
http://www.cheviot4x4.com/shop/Vehicles/Discovery/Cat/Performance/Product/300%20Tdi%20EGR%20Blanking%20Kit/
My ex EGR is below......
auf_wiedersehen_pet:
--- Quote from: auf_wiedersehen_pet on January 03, 2008, 21:14:41 ---Did not notice any difference though.
--- End quote ---
Before I get any comments, I did reconnect the air filter in the 2nd photo.
:twisted: :twisted: :twisted:
freeagent:
its not a CAT, its a particulate filter (as advised by my MOT inspector, who is a landy specialist) you can bin it as there is no requirement to keep it, as long as your truck still passes the emissions test in the MOT.
I binned mine at the weekend, and fitted a 300Tdi defender downpipe, i've already binned the EGR and tweaked the fueling slightly... it goes quite nicely now. :grin:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version