Vehicle & Technical > Discovery
Wheel Balance
J B:
i had a set of 5 general AT2's less than a year old i changed the wheels ans they could balance 3 of em, wheels were fine :cry:
chris9119:
--- Quote from: "nicr1" ---thx..as soon as i find out where it is i'll check to see if it's blocked :roll: .....i'll get the wheel off tomorrow and have a proper look,.....would it be possible to cause a blockage by poking rust out of my boot floor.?.....loads of corroded bits were falling all over the axle when i was poking about the other day...did'nt notice the leak at the time.but thats not to say it was'nt there.
--- End quote ---
The West Midlands crew are always around and on hand for any assistance needed. Just pop along to the next meeting and say hello...., we maybe having a maintenance day in the not to distant future where you'd be more than welcome to come along and learn about your LR.
All we ask is that you put in a little bit to the Group.
nicr1:
major dillema as i need a car for work on wednesday which is 35 miles away....so..do i:-
A). spend tomorrow stripping down the disco in the hope that i can diagnose the problem and hopefully make it over to Rimmer bros Land Rover in lincolnshire(75 miles away) New years eve to get the parts, because they seem to be the only people open and then spend new years day bolting it all back together ready for work the 2nd of Jan.
or
B.)Spend tomorrow trying to find a cheap runaround.
i think that guy who said i should check the disco over more often might not have been too far off the mark...all my own fault i know... :?
chris9119:
--- Quote from: "nicr1" ---i think that guy who said i should check the disco over more often might not have been too far off the mark...all my own fault i know... :?
--- End quote ---
nicr1
Where are you in the Midlands? and what model is your Disco.
I maybe able to assist, but no promise's at this time.
I do have a stock of 200 & 300 tdi axle sets (wheel bearings and seals).
nicr1:
chris...thx a lot.first of all, i'd deffinately be interested in the workshop day.and secondly i'm in coventry....plan B is to use my ktm620 (on knobblies) if all else fails, so i have got transport to pick up parts if you manage to find any.
I really don't want to rely on having to ride it 35 miles to work each way until i sort something out, but i will/have to if need be.
thx, nick.
disco is a 200 tdi, on a K plate.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version