Vehicle & Technical > Discovery

brake probs...

(1/2) > >>

paul.p:
got a brake pull to the right on my 300tdi, when had tyres changed last week found grease on back of n/s front disc and on pads, swivel leaking...  today i cleaned all grease up, had disc off, no grease left on that, fitted new pads, but still got brake pull.so thinking poss by a sticking caliper?? so if gotta change caliper are 200/300 ones same? and read something about 110 calipers being a good swap? help please!

bilge rat:
are you sure it was the swivell causing the fault . usually its the inner wheel brg seal which causes this. the pads are then well contaminated. think i left mine in genclean then swapped 1 with the other side . alan.....

paul.p:
well i just guessed the swivel as it is pitted and covered in grease too.....
another job on list, just need to get brakes sorted as its my daily motor

bilge rat:
my swivel went like that but it didnt get on the pads , have a good check im pretty sure youl find its the inner brg seal. was a pig when mine went, good luck. alan.....

Range Rover Blues:
Yes 110 callipers should fitas they are single circuit like yours.  Make sure you get the vented ones though if you have vented disks!

Navigation

[0] Message Index

[#] Next page

Go to full version