Chat & Social > The Bar - General Chat

I need some help with this one

<< < (2/3) > >>

wizard:
It on a similar line to the last one.
I'll post a picture later so you can see what i'm after.
The reason i need this perticular tipe is that the lamp fitting was modified years ago to accept two 24vdc truck headlight bulbs. Its beams two bright narrow beams of ligt across a machine used to roll the side walls on pressure vessles.
The light beams allows our fabricators to accuratly roll a flat bit of steel into a prefect cylinder.

Regards
wizard :twisted:

ChrisW:
I've had good service from these before - http://www.fortrans.fsbusiness.co.uk/

wizard:
This is what i need. It called lovolite but a search doesnt find much.





regards
wizard

waveydavey:
Are you sure that you have a transformer in the light part? It may well be supplied from the control circuit of the main machine?

wizard:
If you take the front off there is a 415 to 48 volt transformer mounted on it.

wizard

Navigation

[0] Message Index

[#] Next page

[*] Previous page