Vehicle & Technical > Discovery

right springs ?

<< < (3/3)

clbarclay:
What brand lift springs where they and what spec or part numbers were they?

There are a lot of different "lift" springs available, it could be the rears and the fronts are not a suitable match for your disco.

bodgeitjo:
cheers every one loads of replys the best thing to do will be swap them around and hope fore the best. have got winch so not that one. did measure the hight but not thickness. tallest on back tho. as for make ect pass, there yellow.   if dry enough at weekend will swap them around then hope for rain so can go and play. :lol:

corrosiverob:

--- Quote from: "bodgeitjo" ---hi all, just put some +2 springs on i got from old sodbury. i put the slightly longer ones on the back. but the front still sits higher than the back. drives fine but just dont look right. :?  any ideas.
--- End quote ---


Wrong way round mate ... trust me i have don it!

clbarclay:
Chances are a yellow lift spring will be made by britpart, which should make working out what spec they are easier.

Compare the free lengths to the manufactures specs in the link below should help find just which ones you have.
http://www.britpart.com/page.asp?MenuRef=59


From the information though the rears should be taller than the fronts, unless you have to sets of rear or similar :? What free length were your springs?

Jake:
Of all the springs i've seen the longer ones go on the front
That applied to the Scrap orange ones i had and all the Old Man Emu ones i see.
 8)

Navigation

[0] Message Index

[*] Previous page