Chat & Social > The Bar - General Chat

x-eng fan switch

(1/1)

burgerman:
Hi all, i have cured lots of issues with my heating recently, with help from certain M/C members, But i purchased a x- eng fan switch to control me leccy fans, great quality product, but the switch i got from l/rover cuts in too high for my liking,( just before the warning light comes on) which for a V8 is not too healthy, i took it out and tried to find a heat spec on it , but none found, anyone use/got any ideas what heat spec to run? or fitment from another vehicle ? so i can pop down the factors and get one locally. Cheers for any replies

 P.S its a 1991 V8 disco

bob86:
I think there's a list of different switches and what temperature they cut in at on the x-eng site.

Edited..

here you go.
http://www.x-eng.co.uk/X-ThermData.asp

paul_humphreys:
I had the same problem with mine. As per the link theres lower ones. I went for 50101   84-79/88-83  with my 200tdi auto and not a problem since.

Most motor factors sell them.

Paul

burgerman:
Cheers for the link, i see the one they recomend is 88-93 degrees
  So if i wanted it to cut in earlier i would need  86-76 ?? or would that be too low ??    Dont want to really buy/try/swap over a few of these unless i have to :?

Navigation

[0] Message Index