Vehicle & Technical > Discovery

Remove propshaft?

<< < (3/3)

Ja1983:
point to note:

if you suspect a propshaft fault, then removing a prof to isolate the cause is ok, but dont forget you are then putting twice the stress on the remaining prop.....

food for thought :wink:

Range Rover Blues:
Jamie, did you check the state of the rubber bush in the end of the prop? it's the one the spigott goes into to locate the propshaft.

If not you might find as I did that the rubber doughnut doesn't last very long before it's vibrating again.

Navigation

[0] Message Index

[*] Previous page