Vehicle & Technical > Discovery
Replacing the seats
Mr Alford:
due to a fair bit of offroading my drivers seats is starting to collapse so i am going to go about fitting some bucket seats but not mega stiff ones a nice set of recliners like below
the only problem is i have a 3 door disco and need to get in and out so welding them the the floor isnt an option please can anyone post pics of what they have done
i have been advised that maybe welding a plate to the top and fabricating new runners but its never that simple
russ3120:
all I did when fitting bucket seat to my 3dr disco, was to get a thick shet of ali and bolt the seats to that then bolt it to the original seat mounts.
russ
Guardian.:
as above, just fix to the origional seat mountings so they still tip over to get in the back.
Mr Alford:
--- Quote from: "russ3120" ---all I did when fitting bucket seat to my 3dr disco, was to get a thick shet of ali and bolt the seats to that then bolt it to the original seat mounts.
russ
--- End quote ---
do you have any pictures of your work?
Ralph Hardwick:
Have a look here:
http://www.4x4response.net/fforum/index.php?topic=284.0
This is how I fitted rangie seats to my disco.
The priciple will be the same for just about any seat.
Hope this helps
Navigation
[0] Message Index
[#] Next page
Go to full version