Vehicle & Technical > Discovery
boot floor gone bye bye
cardiff_gareth:
--- Quote from: "gee the sparky" ---wheres the cheapest place to get a new floor section? as mine looks worse than those already shown.
--- End quote ---
paddocks - free delivery over £50 orders :wink:
discoverytdi:
ok ready to be shot down in flames but considering the problems with Disco floors, is there any reason why you couldn't replace it with thick ali plate. mines perfect by the way phew :D 1996 300 Tbi 88000 mls
Evilgoat:
I have a thick ally chequer plate and under that GRP clad MBP.
It does work rather well however the rails are noe rotted through as are the sides. I'd rather have an original part in the personally. You have to remeber the ribbing in the OEM part of for strength.
Thinking about refitting mine semi permanently as bing able to remove the floor has made some of the jobs I've had to do a LOT easier. I have seem some seriously strong bayonet type fasters I want to use, normally found on aircraft panels. Just sourcing some is a pain.
like these :
J B:
spent the afternoonwelding up the rear body cross-member
stuntman:
Well I've found out last night that sadly I don't have a boot floor anymore, looks like I need to replace the whole lot aswell,
So it should be fun as it will be my first piece of welding on a car, I have a mig welder with gas, however I have no gas, can someone tell me what would I would need to ask for?
Regards Andi K
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version