Vehicle & Technical > Discovery

Rear Axle Shock Mount

(1/1)

feenix:
has, er... fallen off  :evil: Is this common on Discos?  The mount looks paper thin along one side (rust?), the other has just fatigued through.  Axle is pretty rusty, is there a chance of welding on a new mount if they are available? If not I guess I'll need another casing and spend some time swapping the bits over or just chance a breakers axle. :(

Big Rich:
Not 100% sure but try Paddocks 08454 584499 (UK local rate)

They are normally good. If not it will be a call to an inderpendant specialist.

I use Rockingham Land Rovers 01536 770078

I hope this helps

Rich

Range Rover Blues:
Check the state of all the other axle brackets as they are likely to suffer the same fate with more severe consequences.

clbarclay:
If one mount has rusted through then I would check the whole of the axle casing carefully, the spring mounts will probably be rotten too.

Navigation

[0] Message Index