Vehicle & Technical > Discovery
D.I.Y Snorkel - I'm going for it! (any advice welcome!)
stuntman:
Well I went off to B&Q tonight and picked up 2m of 68mm black down pipe, 2 45 degree's and 1 90 degree bend, and a couple of brackets and some plastic glue and black mastic/ silicone.
I'm a little concerned about the wing cutting, has anyone a guide I can print off that's a step by step idiots guide or can anyone post any tips at all?
Andi K
Oh and I'll hopefullt do a picture guide of the install if it can help anyone else!
russ3120:
i went down the B&Q route to, you will need a 135 degree elbow to
Skibum346:
--- Quote from: "stuntman" ---Well I went off to B&Q tonight and picked up 2m of 68mm black down pipe, 2 45 degree's and 1 90 degree bend, and a couple of brackets and some plastic glue and black mastic/ silicone.
I'm a little concerned about the wing cutting, has anyone a guide I can print off that's a step by step idiots guide or can anyone post any tips at all?
Andi K
Oh and I'll hopefullt do a picture guide of the install if it can help anyone else!
--- End quote ---
Andi, check the engine bay for rubber covers where the safari snorkel would enter. I had one either side and they cover up pre drilled internal holes. All I did was drill a pilot hole from the inside before using a hole cutter from the outside. Then a little finishing trim.
If you've not already done so... check out my gallery for photos and here for a write up.
**Clicky Now Correct! Thanks Paul!** :oops:
Skibum
Chris Putt:
Might do mine tomorrow if im feeling daring!!! :roll:
suggs:
--- Quote from: "russ3120" ---i went down the B&Q route to, you will need a 135 degree elbow to
--- End quote ---
Russ
whats tyres are on your Disco??
Navigation
[0] Message Index
[#] Next page
Go to full version