Vehicle & Technical > Discovery

Clutch AGAIN ** SORTED **

<< < (2/3) > >>

Les Henson:
A reinforced clutch fork:-



What happens to them:-



Stengthened with a 2.5mm plate :-



Les.

barmiebrumie:
All done  :D ,



Had to replace the master cylinder & damper, had a real probelm bleeding though ended up ' drip bleeding' in the end (open bleed nipple & keep topping up for about an hour),

I had replaced the gear & transfer box's about 3 months ago, (R380 gearbox & 1.41 transfer box) while that was being done I welded a bar on the fork,


Thanks for all the advice

meader:
i have just replaced my clutch and just put the box back up problem now is ever time i press the pedel it stays on the floor and i have to reach down and lift it back up by hand but it was working fine till the clutch went

Les Henson:
On a 300TDi Disco the clutch pedal 'goes over' if there is air in the system, so when you are bleeding it you have to press down and pull up. Once the air is gone the pedal doesn't travel far enough to do this.


Les.

meader:
i have tryed bleeding it for20mins still the same im getting no pressure build upwot so ever so i going to have to take the box back out i think

Navigation

[0] Message Index

[#] Next page

[*] Previous page