Vehicle & Technical > Defender

Chequer plate sill panels

<< < (2/3) > >>

sleepy straven:
I put my sills on with pop rivets. Once I had drilled through both I surrouned the holes with silicon and a bead around the outside edge of the plate. Once the plate was riveted on the silicon squished out a bit and was cleaned off. The wee strips on the rear quarters I have seen before but not sure if they are made or bought.

Darren:
Thanks Sleepy, pop rivets and silicon I can do :)

DiscoveRay:
I bought my 110 sills at the Peterborough Show, £25 pair or £35 powder coated.

Haven't fitted them yet.

They also supply 110 rear corners for £18 pair or £25 powder coated.

I can't find their brochure and can't remember where they're based, but I have the price list and mobile numbers:

Simon 07786 021088 or Mark 07899 992429.

Says on the price list that 'other parts are becoming available, call for ideas and a chat.'

Ray

Daz800:
i did my 90 using off cuts from work,using 3mm 5 bar plate
when i made my sills i made them in one peice and linnished the ends to copy the lr ones

all my pates are rivited on.
i can post photos if required

Daz

Darren:
Oh yeah, pictures are always good :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page