Vehicle & Technical > Defender

Can I...........

<< < (2/2)

Jimbo:

--- Quote from: "Jas278" ---Early Td5 also have diff lock just no gear stick, If you look on Disco parts I think that gives the serial numbers for identfying  if the tranny box has the bits req inside..
--- End quote ---


You mean Mark C's site - can't see the info anywhere, gis a clue please Jas !

Jim

Jimbo:

--- Quote from: "Xtremeteam" ---
--- Quote from: "Jimbo" ---..........put a Td5 Disco transfer box straight onto a Td5 Defender ?

I'm toying with the idea of raising the high range ratio, Ashcrofts do an exchange service, but I may be able to get hold of a complete Disco T-box.
--- End quote ---

why not put a 300tdi Tbox in as the rations are the same unless u are after the Q (quiet) gear setup
--- End quote ---


Mike - assume you mean 300tdi Disco Tbox, does it bolt straight on ?

I'm not fussed about the Q gears - the stereo should drown out most of the noise...... :twisted:

Richie_EB4:

--- Quote from: "Jimbo" ---
--- Quote from: "Xtremeteam" ---
--- Quote from: "Jimbo" ---..........put a Td5 Disco transfer box straight onto a Td5 Defender ?

I'm toying with the idea of raising the high range ratio, Ashcrofts do an exchange service, but I may be able to get hold of a complete Disco T-box.
--- End quote ---

why not put a 300tdi Tbox in as the rations are the same unless u are after the Q (quiet) gear setup
--- End quote ---


Mike - assume you mean 300tdi Disco Tbox, does it bolt straight on ?

I'm not fussed about the Q gears - the stereo should drown out most of the noise...... :twisted:
--- End quote ---


Yes there the same......just have to change the output propshaft flange on the front.

Ricky:
Didnt the workshop section on this forum show how to fit the CDL onto a td5 subject to the box having the correct unused bits inside. seem to remember considering it for mine. But where's the workshop gone???

Jimbo:

--- Quote from: "Ricky" ---Didnt the workshop section on this forum show how to fit the CDL onto a td5 subject to the box having the correct unused bits inside. seem to remember considering it for mine. But where's the workshop gone???
--- End quote ---


Yes, I think it did. But, if a box out of a 300tdi will fit, then that's probably the easier route as I'll only have to change the front output doofah, and not muck about trying to lash up the difflock lever.

Navigation

[0] Message Index

[*] Previous page