Chat & Social > The Bar - General Chat

breather bolt????

<< < (3/3)

disco-v8:
didnt want to just stick anything on with just silican, like a tyre valve, i wanted to bolt it on and seal it with siliocan....

i saw a few things that you just push the hose into it, but i didnt thing that would seal very well from water, so i just gone and bought my self some 5/16 hose tail fittings with a 1/8 bsp thread so can bolt it on....

should be able to fit a small hose onto that  :D

ill keep you informed when i fit it

Terranosaurus:

--- Quote from: "disco-v8" ---didnt want to just stick anything on with just silican, like a tyre valve, i wanted to bolt it on and seal it with siliocan....
--- End quote ---


A tyre valve wouldn't be stuck on with silicon, you could fit one just as you would on a wheel, and guess what they are air and water tight to start with so don't need silicon, was just an idea, you can get extenders for them too, so instead of pushing a tub over the end it could screw on.

MuddyMike:
Just drill down the center of a bolt and make one. That is what I did to run a vacuum line through my dizzy. Helps if you have access. to a drill pres, as doing it freehand is a bit difficult.

Mike

extreme90:
adam, go down city breaks, they will have some small 1/8th bsp pipe fittings
just will need to drill and tap it out
i might even have one lying around here  :?  :?
ill ring you tomorrow day, later on tho so dont disturb your sleep if i find one

Navigation

[0] Message Index

[*] Previous page