Vehicle & Technical > Discovery

How do i remove the crankshaft pulley!

<< < (2/3) > >>

bilge rat:
as above but disconnect the shut off solenoid so it dont fire up, alan....

Yoshi:
It wont fire anyway cos the belt is snapped so the valves wont open as yet!  but it wont be much longer.

bilge rat:
ouch, missed that. but id do it any way. have you lifted the rocker cover yet, you might be lucky . just a few bent pushrods. valves dont usually bend but rocker arms can brake. good luck. alan.....

Yoshi:
Yeah, had the rocker cover off, rockers are intact, so just bent pushrods which i have purchased 8 new ones which will be alot easier than searching for bent ones.

Chris Putt:
Did one on a 2.5 td 90 a few months ago, to stop the engine turning over we put it in gear, parked against a wall, with a set of steelsons (pipe wrench) on the rear prop wedged on the floor. then undid it with a scaff bar on a breaker bar on the socket..........improvisational farm mechanics.........

Navigation

[0] Message Index

[#] Next page

[*] Previous page