Vehicle & Technical > Range Rover

joining the seems

(1/3) > >>

way2deep:
ok so you chop the back off to bob tail but how do you join em back together?

Paul:
Leave a bit extra on the panels,
Fold them over making a lip,
Drill and bolt them together. :wink:

Range Rover Blues:
Most people 'move' the joint in the rear quarter so you only have one seem to re-make ie the one at the rear of the side-panel, the corner panel remains untouched.

MUSKIE:
mine had the origional lip cut off the quarter panel and pop riveted back on farther down.

muky-kid.:
:D  The side panels was the easy part, the roof is a pain to get right as it tappers towards the rear, my mate tucked about 1 1/2" of the rear section under the front peice and useing the original little crome clamps held it place whilst he riveted along the joint along both sides of the joint then skimmed over with filler and sealant then covered the roof with ( cant remember what its called now ) that black immitation leather stuff. I know theres a word for it but cant remember what you call it  :? .  Must go to bed now its been a long day.  :lol:

Navigation

[0] Message Index

[#] Next page