Chat & Social > The Bar - General Chat

Chequer Plate

(1/2) > >>

BigSi:
What's the best way to cut 3mm chequer plate (5 bar)?  :-k  :-k  :-k  :-k

wrecker:
would i be right in saying a decent jig saw :(

thats what i used to cut the stuff :)

hope some one elce will be along to help in abit :D

mark

lambert:
Jigsaw with lube (can denature hardened ally cause of heat) or angle grinder with a metal cutting wheel.

edy:
i would say an angle grinder (preferably with a diamond blade, a lot better) or a recipicator.

MudRat:
i use either a jigsaw and WD40 or an angle grinder iwth a stainless steel (thin) cutting disk, the thick metal cutting disks are too clumsy!

Navigation

[0] Message Index

[#] Next page