Vehicle & Technical > Discovery

AAArrrrgggggggggg

(1/2) > >>

gtomo2:
Well got both of my engines side by side ready to swop over the clutch plate. Old engine is off a manuel new engine from a auto. And looking at the rear plate on the old engine there is a small bush that fits inside the rear plate attached to the crank and guess what the auto engine dont have one just a bigger hole were it should fit. So really fed up now as i havent a clue were i would get this bush or how i would get this bush (its my only motor).. :evil:  :evil:  :evil:  :evil:  :evil:

dazzawhipple:
No much use but I (think) have a spare bush here in Northants

I got mine from John Craddocks

Darren

gtomo2:
Got the bush out using a very special tool Sooty(bev) is the expert at using this tool. :wink:  8)

hobbit:

--- Quote from: "gtomo2" ---Got the bush out using a very special tool Sooty(bev) is the expert at using this tool. :wink:  8)
--- End quote ---


What angle grinder :shock:

It sounds like you are talking about the spigot shaft bearing?

gtomo2:
No got the bush out in one piece. Will put a pic up of it it's only very small. But if you want one i could sell you one for about £100 and double if you need bev to show you how to use it. :lol:

Navigation

[0] Message Index

[#] Next page