Vehicle & Technical > Discovery

Ideas regarding making an exhaust fit...

(1/2) > >>

Steven:
Hi everyone,

Bought a straight through exhaust middle part, got told it was a straight fitment to your stoke ehaust system, just measured it and its too short by a couple of inches. How can we get sround this? Could I use some flexi pipe in between the straight through and where it joins on the rear box section? Thanks in advance.

clbarclay:
Can you losen the clamps on the rear section an slide it back enough for it too fit?

Steven:

--- Quote from: "clbarclay" ---Can you losen the clamps on the rear section an slide it back enough for it too fit?
--- End quote ---


Could do I'm not sure...

Budgie:
If it's the wrong one then take it back and get the correct one.
I've seen a few of these for TD5 Discos, make sure it's not one of these and is built for a 300 series.  :wink:

Steven:

--- Quote from: "Budgie" ---If it's the wrong one then take it back and get the correct one.
I've seen a few of these for TD5 Discos, make sure it's not one of these and is built for a 300 series.  :wink:
--- End quote ---


The bloke don't sell anymore. Not replying either to my emails.

Navigation

[0] Message Index

[#] Next page