Chat & Social > The Bar - General Chat

best mod i have made in a while

(1/2) > >>

Xtremeteam:
on christmas day whilst  every1 else was tucking in to there crimbo dinner i was out side lyining on the ground trying to replace the clutch slave cylinder i knackered at drumclog bout 3 weeks ago so i could compete in the boxin day bash/auto test with slroc.
after spending most of the day trying to hook the daft plastic clip that holds the pin in 2 the clutch fork back on after the pin fell out when i removed the old slave cylinder i was a bit stressed & cold & had dirt in my eyes so Mr Holesaw made an appearance again,
time taken up to the point where the holesaw came out the cupboard 3 hrs
time taken after the holesaw incident 20 min  :evil:

muddyweb:
How are you planning to seal the bellhousing back up ?

Xtremeteam:
dunno yet,make a small alloy plate 2 cover the hole up,dnt hve 2 worry bout it for now as the nxt event isnt till feb i think so ive just got 2 paint it,replace the back brake drums,replace all the springs get it vinyled & cover the hole up

Range Rover Blues:
Areldite

davidlandy:
duck tape, cable ties and silicone sealer

 :wink:

a good idea , drill holes all over your motor like that, just imagine how much easier some jobs will be! .......and how much lighter it would be too.

Navigation

[0] Message Index

[#] Next page