Vehicle & Technical > Discovery

Suspension .....

<< < (3/3)

Range Rover Blues:
I've seen a few atempts at disconnects and they looked pretty ropey TBH, one of the worst being to replce the nut on the special bolt with an R clip :roll:

clbarclay:
One of the neatest disconects I've seen was for a jeep which have relaticerly longer links between the axle and arb, on of these links was replaced by a sliding one which was simple released/reconnected by reponing/fitting a linch pin.

Range Rover Blues:
I'd thought about doing something similar as the links wouldn't hurt to be longer on a LR either.  The problem I found with my Rear ARB just be unbolting it is that it flaps about in the way and digs in or hits the underside when you articulate, so it needs fully disconnecting both sides and securing to the chassis when not in use.

Navigation

[0] Message Index

[*] Previous page