Vehicle & Technical > Series Land Rovers
Wiring
Henry Webster:
--- Quote from: "mark.yellow.series.3" ---i rewired mine from scratch,
--- End quote ---
Where did you get the bus bars from? They look good.
When I was considering doing the Series 1 I spoke to Autosparks who do replacement looms. I was struck by the fact that their prices were probably cheaper than doing it from scratch myself, plus they were happy to include extras or modifications.
http://www.autosparks.co.uk/
H
mark.yellow.series.3:
i got them from www.lsuk.co.uk
i ordered them from the DURITE catalogue, just the job 8)
The Landy Guy:
--- Quote from: "Bob Ajob" ---dunno on age...
If it's a Lucas and it's got a bit on the back that looks like it comes off like this (on the bottom of the pic on the right):
This bit's the regulator:
--- End quote ---
i believe its a lucus and it has a small plug that comes off the back, that mean anything?
Bob Ajob:
It probably looks a bit like that one above then from the back of it. The Lucar connector is common amongst the same alternators, essentially a block with three spades in it.
Assuming anything is generally not good, in this case though I would assume you have no regulator as the alternator has one...
Did you do the alternator conversion yourself or was it already done?
The Landy Guy:
already done and just to let you know the landy had no wiring in at all so i don't know if it hand an regualtor before hand
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version