Vehicle & Technical > Range Rover

Bobtail 4dr Rangie

<< < (2/2)

Chris Putt:
Depends how nice you want it to look, seen a roof done simply by cutting it then riveting it back together, then liberal quantities of mastic!

zulublue:
Have a look at minein my photos, it was done when I got it, but they have cut the roof above the drivers seat, thus no arse droop on the roof, a shame really as im breaking her down now.

lee555:
hi, sorry for replying 2 months after your post, very new to the site, im in the process of bobbin a 4 door rrc, its been a labour of love(18months of spare time), the rear quarters, i cut and rejoined the alli panel so as to leave the lip that mounts to the corner and remove the fuel filler bit, did this with alli wire in a mig welder, doesnt look very nice from the inside but cant see join from the outside(much), the roof, i cut the middle section out and attempted to do the same process but didnt realise the roof is slightly wider at the back than the front, the answer was to fit a cheap sunroof(£20 nissan micra one from ebay)this allowed the roof to relax instead of trying to bulge upwards, ive taken lots of photos, if youd like a copy i could send a cd, they would probably be more use to show how not to do it and save some time. :oops:

Navigation

[0] Message Index

[*] Previous page