Vehicle & Technical > Suzuki
Oh the humiliation!
Evilgoat:
Towed into Billing behind EA51 MUD then taken home on a low loader.
Comming off the dual carriageway 2nd to last roundabout and cluth locks out. Adjusted it yesterday, gave it a good clean etc externally as its been a bit odd for weeks. Was sweet as a nut yesterday, nice snappy, easy gearchanges agian, not needing to wedge myself in the seat to push it to the floor etc.
Tried tightening up the adjuster at the show to see if a little more would pull it free but I suspect its jammed on the splines or welded to the flywheel.
O how I am not looking forward to doing this. Any recomendations for a new one. Also parts as I'll attack the other jobs that need doing, gaskets etc.
Not best pleased. have a pounding headache as the recovery truck had a wheel way out of balance and it was like riding home on a windy hammer.
Ja1983:
..sure its not a frayed cable? (if its a cable clutch!)
had similar trouble on a nova, tried a cable prior to a new clutch and sorted problem!
good luck :wink:
Evilgoat:
--- Quote from: "Ja1983" ---..sure its not a frayed cable? (if its a cable clutch!)
had similar trouble on a nova, tried a cable prior to a new clutch and sorted problem!
good luck :wink:
--- End quote ---
Will manually force the leaver back before I try anything else to rule that out. Its possible I guess.
generation-x:
dear oh dear rich and ali
so 1st you go to a landy show 2 u have to be towed there too ??
you shud of come to the JAE least you wud of got towed by a jap car/4x4
:(biglaugh):
simon
Evilgoat:
--- Quote from: "generation-x" ---dear oh dear rich and ali
so 1st you go to a landy show 2 u have to be towed there too ??
you shud of come to the JAE least you wud of got towed by a jap car/4x4
:(biglaugh):
simon
--- End quote ---
:smack:
Thats right, rub it in some more. Mate in Calgary managed to nuke his truck before the clutch got changed so he's gonna get a cost on sending it over for us. Debating to follow the haynes manul and take everything bar the engine out, or do the reverse and pull the engine. Might make a few other jobs easier that way.
Loads of MC members saw us on tow/being loaded up buit one one comment yet.
Navigation
[0] Message Index
[#] Next page
Go to full version