Vehicle & Technical > Discovery
disco truck.
clbarclay:
The replacement front inner wings for mine were designed to fit on earlier RRC where the front wings were origionally bolted on. I still had to weld the front of the replacement pannels on as they were on part front inner wing assemblies, but I bolted them to the bulk head which was easier than welding.
One down side with this, its possible to spend more on replacment inner wing assemblies that some RRCs are worth. The other is I haven't seen wing replacements pannels for discoveries so you would probably have to addapt RRC pannels to fit instead.
boss:
http://www.yrm-metal-solutions.com/page5.htm
clbarclay:
The YRM one look like just a repair section
The SPI ones I got were more like pattern parts (complete with bigs like the brake line mounting bracket) than repair sections
And like I say for a RRC you can get prety much the a hole new front end to bolt on
but it will cost around £260 for the privalage.
bobthedisco:
i used RRC inner wings on my disco, i removed the RR headlamp boxes and used the disco ones :)
i wouldnt run without inner wings...would be ok if you want to plant some vegetables on the engine after an offroad session :lol:
your intake temps wont do your performance any good either with the airbox there....it will be acting as an interwarmer :grin:
i,d move it back if i was you ;)
jonny ramrod:
'interwarmer'..... :lol: :lol: :lol: thats ace
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version