Vehicle & Technical > Discovery
disco truck.
boss:
hahaha to true.
ran into a bit of a problem today, where the rear and middle windows mate to the car there is that curve in the body pannel, i was going to cut 2inches off of that and put in a bit of 2"x2" box to make it a wee bit stronger but my recip saw or my grinder wont fit properley because the end of the saw hits the alli pannel which is not what i need, and the grinder wont fit properley so i had to order a plasma cutter for monday. if i had just bit the bullet and got one to start with it would be all done by now!!!!!
boss:
how it started today
thats the way we do it! those jacks are ok but there reley unstable!i did get it higher than this but then the jack shifted sideways and so did the car!
what im doing is cutting(the plasma cutter came btw!)the inside sills to make a ledge so i can weld some box section around the truck bed.
looking good so far. theres alot of excess chasis to be lost though
untill tomorow
boss:
no comments...should i even bother anymore?????
the bar going around the truck bed
chopped the chassis
puncture faries visited lastnight!
SHERMAN TANK:
Don't be put off, i think everyones watchin open mouthed :o .
You certainly got some balls for someone of you age :)
Keep it up its lookin good.
shaun and co:
defo- keep it up- to say im intrigued is an understatement......... :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version