Vehicle & Technical > Discovery
Confusion over sills/sliders?
Skibum346:
--- Quote from: "simon15" ---lol....
The best way seems to be to put in a box section.
Anyone got ideas on sizes to use and a rough measurments etc?
--- End quote ---
No.... :roll: but I can recomend a good tape measure....!
:(biglaugh)::(biglaugh):
:(biglaugh)::(biglaugh):
:(biglaugh)::(biglaugh):
dazzawhipple:
Frank,
Did the UK go metric some years ago?????? imperail tape!!!!
Skibum346:
--- Quote from: "dazzawhipple" ---Frank,
Did the UK go metric some years ago?????? imperail tape!!!!
--- End quote ---
:oops: :oops: :oops:
B....y Americans!
simon15:
:(biglaugh):
Where do i need to measure? just where the existing sill is at the mo? just add more to the depth so it brings it down lower.
Skibum346:
--- Quote from: "simon15" ---:(biglaugh):
Where do i need to measure? just where the existing sill is at the mo? just add more to the depth so it brings it down lower.
--- End quote ---
This is how I'd do it assuming there is enough of a sill left to weld to... otherwise, you'd have to cut back and weld to whatever is left.
Click here for diagram
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version