Vehicle & Technical > Discovery

Rear prop shaft?

(1/2) > >>

skiprat:
Hi,

Im not sure if this has been covered, but i couldnt find anything in the search.

My rubber uj type thingy is looking like it could go at any time. so rather than replace it i was wandering if i could fit a rear prop from a 200tdi instead? would it be a straight swap or is there some fettling involved?

many thanks

Kris

Disco-Ron:
The 200 prop has a 4 bolt fixing on the rear, where-as the rubber thing i believe has a 3 bolts fixing, i'm not sure if the flange on the diff is interchangable, i'm sure somone out there will know though!!

BtB:
The Rear diff flange needs to be changed for the 4 bolt version. I don't know about the 200tdi propshaft (as i fiited an aftermarket prop)

I have done this and fitted a wide angle prop

Jake:
Why dont you just buy a new prop doughnut?
They arn't that expensive
 :D

Dr Neil:
Yes mate all you need to do is get a 4 bolt flange and it will bolt straight onto your diff.The only problem you may have is removing the origonal flange if you don't have access to the special puller.


hope this helps

Neil...

Navigation

[0] Message Index

[#] Next page