Vehicle & Technical > Discovery

Discovery Axle/tranfer/gearbox breathers.

(1/4) > >>

Chris Putt:
Looking at the cheapest way to put breathers on my Disco's axles/transferbox/gearbox, anyone know where I can get the correct banjo bolts (someone mentioned some fuel fittings may work?).

Cheers

Chris

Disco-Ron:
I bought this http://cgi.ebay.co.uk/LAND-ROVER-Gearbox-Axle-Breathers-The-Ultimate-Kit_W0QQitemZ170119249351QQihZ007QQcategoryZ31348QQcmdZViewItem
granted a long way from the cheapest option, but it's all there nice n neat!

stageonesimmo:
Micro-irrigation pipe from the gardening section of B&Q - It pushes onto the existing fittings once you've cut the old pipe off carefully so as not to score the metal pipe, then route it along the chassis up to bulkhead level as high as you want - I did my front and rear axle for less than a fiver.  Once I have a snorkel fitted, I'll just 'T' the 2 pipes together into one, same with the g/box and t/box then route the 2 pipes up the snorkel to get them as high as possible using the 5M or so I have left on the roll I bought.  Easy.

chris9119:
Don't forget the fuel tank breather :wink:

Chris

Dr Strangeglove:
What size fittings are required?  Are they a BSP size?

Navigation

[0] Message Index

[#] Next page