Chat & Social > The Bar - General Chat
warn spares
davidlandy:
have you taken out the little grub screw and removed the lever?
90Mike:
tried to remove it but was to tight :roll: i am going to take it to work with me tomorrow and soak it in the parts wash all day then give it another go :? is it possible to strip the unit completely :?:
davidlandy:
yes u can strip it completely - dead easy and worthwhile
the clutch is a chunky unit so it would be difficult to break.
the main thing to watch is that you set up the brake properly when reassembling otherwise it wont hold.
post some pics when you get a minute
90Mike:
:shock: :shock: :shock:
( the main thing to watch is that you set up the brake properly when reassembling otherwise it wont hold. ) :shock: :shock: :shock: .There is a way of setting them up :?: its not just a matter of slotting it all back in together then :oops: :twisted: :twisted:
davidlandy:
no - I found out the hard way!
one way only otherwise it wont work
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version